Taking Pictures23Shoot.● Press the shutter button fully.X The camera will play the shutter soundand shoot. The flash will automatically firein low light conditions.X The indicator will blink green while theimage is recorded to the memory card.X The image will appear on the screen forabout two seconds. You can continueshooting while the image displays.• nothing displays when the camera is turned on?Press the ⁄ button to turn on the screen (p. 43).• the camera does not play any sounds?Pressing the ⁄ button while turning on the camera power will turn off allsounds except for warning sounds. To turn on sound, press the · button,select the 3 tab, then select [Mute]. Use the qr buttons to select [Off].• the image comes out dark even the flash fired when shooting?Subject is too far away for the flash to reach. Shoot the image within theeffective flash range of approximately 30 cm – 4.0 m (1.0 – 13 ft.) at maximumwide angle (j side), and approximately 30 cm – 2.0 m (1.0 – 6.6 ft.) atmaximum telephoto (i side).• the indicator blinks yellow and the camera only beeps once when theshutter button is pressed halfway?Your subject is too close. Move about 50 cm (1.6 ft.) or more away from yoursubject. Press the shutter button again halfway, making sure the indicator doesnot blink yellow before taking the picture.• the screen turns off when you take an image?When flash recharging begins, the indicator may blink orange and the screenmay turn off. When recharging ends, the screen turns on again.• the lamp lights?The lamp (Red-Eye Reduction Lamp) lights in order to reduce the red-eye effectthat occurs when shooting in dark conditions using the flash. It also emits whenassisting the focus (AF-assist Beam).What if...COPY
