119Changing Shooting Function SettingsDisplaying the OverlayYou can display gridlines for vertical and horizontal guidance, or a 3:2 guideto confirm the printable area for postcard size prints.● Choose [Disp. Overlay], then press theqr buttons to choose an option.Changing the IS-Mode Settings● Choose [IS Mode], then press the qrbuttons to choose an option.Grid Lines A grid overlays the display.3 2 GuideGray bars will appear on the topand bottom of the display. Thisarea will not print when printingon paper with a 3:2 aspect ratio.Both Both grid lines, and the 3:2 guidewill appear.• In mode, you cannot set [3:2 Guide] or [Both].• Grid Lines will not be recorded on the image.• The gray areas displayed with [3:2 Guide] are the areas that will not beprinted. The actual image recorded will include the portion in the grayareas.ContinuousImage stabilization is always on.You can confirm the resultdirectly on the display, whichmakes it easier to check thecomposition or focus.Shoot Only Image stabilization is only activeat the moment of shooting.PanningImage stabilization only countersup and down motion. This optionis recommended for shootingobjects moving horizontally.•• If camera shake is too strong, attach the camera to a tripod. You shouldset the IS Mode to [Off] when the camera is attached to a tripod.• When using [Panning], hold the camera horizontally to shoot. Imagestabilization does not work when the camera is held vertically.
