Canon PIXMA iP6600D Series Direct Printing Manual

Also see for iP6600D - PIXMA Color Inkjet Printer: Supplementary guide Brochure & specs Specifications Start here Quick start guide

Contents

Canon PIXMA iP6600D Series Direct Printing Manual Manual pdf 75 page image

71*1 To resume printing, you can press the OKOKOKOK button on the printer instead of selecting ContinueContinueContinueContinue.*2 The waste ink absorber absorbs ink used during cleaning, for example. If this messageappears, you will need to call for servicing to replace the absorber and to check the printer forproper operation.No ink You can check the printer status according to the way the ink tank lamps (red)flash. Check the status of the lamp and take the appropriate action to clear theerror. When the ink tank lamp is off, possible causes are as follows:• The ink tank may not be installed properly.Install the appropriate ink tank.• The ink tank may not be compatible with this printer.Install the appropriate ink tank.See “Replacing an Ink Tank” on page 50. When the ink tank lamp flashes fast (at about one second interval), possiblecauses are as follows:• The ink has run out.Replace the ink tank, and close the cover.If printing is in progress and you want to continue printing, select ContinueContinueContinueContinue *1in the display on your camera with the ink tank installed. Then printing cancontinue under the ink out condition. Replace the empty ink tank immediatelyafter the printing. The printer may be damaged if printing is continued underthe ink out condition.If multiple ink tank lamps are flashing, check how fast they flash. Fast flashing(at about one second interval) indicates the ink is empty. Slow flashing (atabout three second interval) indicates ink is low. For details on differentflashing speeds, see “Getting the Ink Level Information” on page 50.• Some ink tanks are not installed in place, or more than one ink tanks of thesame color are installed.Confirm that the ink tanks are installed in the appropriate positions.See “Replacing an Ink Tank” on page 50.Ink Error/No ink The ink tank that was once empty is installed.Replace the ink tank.Printing under the situation may damage the print head. Canon shall not be liablefor any printer malfunction or damage caused by refilled ink tanks.If you want to continue printing with the refilled ink tank installed, press and holdthe Stop/ResetStop/ResetStop/ResetStop/Reset button for at least five seconds, and then release it. Using refilledink tanks are memorized.* This operation will release the function for detecting the remaining ink level.Hardware Error/No ink The ink tank errors have occurred.Replace the ink tank.See “Replacing an Ink Tank” on page 50.Printer error An error requiring servicing might have occurred. (Printer POWERPOWERPOWERPOWER lamp and AlarmAlarmAlarmAlarmlamp flash alternately.)Disconnect the cable between the printer and the camera, turn off the printer, andunplug the power cord of the printer from the power supply. After a while, plug thepower cord of the printer back in, turn on the printer, and then reconnect thecamera to the printer.If the same error occurs, contact the Customer Care Center.Error message on camera Try This