|
3-4. Verification Items(1) Service test printOn the service test print (sample below), confirm the EEPROM information as shown below.- Top area:iP5300: Model nameVx.xx: ROM versionD = xxx.x: Ink absorber counter value (%)USB (xxxxxx): USB serial number- Middle area:CND: Destination- Bottom area:FA=xx xx xx: Reserved for plant useCDRP(+xxxxxx, +yyyyy): CD / DVD print position correction valueCDRS=(xxxx): CDR sensor correction valueTemp.=xxx: Internal temperatureAB(K=OK Y=....): Ink system function check resultNote: For the ink amount in the ink absorber, confirm it in the EEPROM information print.On the service test print (sample below), confirm the following items:- Check 1, check pattern for top of form accuracy, skewed paper feeding, left margin, and carriage (outermost) accuracy- Check 2, EEPROM information- Check 3, check pattern for horizontal dot mis-alignment: Ink shall be ejected from all nozzles.- Check 4, check pattern for irregular line feeding: There shall be no remarkable streaks or unevenness.- Check 5, destination- Check 6, LF correction value (The value selected in the LF correction is printed in cyan)- Check 7, check pattern for LF correction (the check pattern selected in the LF correction)- Check 8, check pattern for uneven printing due to carriage movement (9600 dpi mode): There shall be no remarkable unevenness.- Check 9, check pattern for uneven printing due to carriage movement (1200 dpi mode): There shall be no remarkable unevenness.- Check 10, check pattern for straight line accuracy: There shall be no remarkable dot mis-alignment on a line.- Check 11, CD / DVD sensor and automatic print head alignment sensor correction: The results shall be OK.- Check 12, Eject correction value (The value selected in the Eject correction is printed in magenta)- Check 13, check pattern for Eject correction (the check pattern selected in the Eject correction)Part 1: MAINTENANCE TABLE OF CONTENTS1-29
|
