Advanced Guide > Faxing > Sending/Receiving Faxes Using the Operation Panel of the Machine > Using the Caller IDService to Reject CallsUsing the Caller ID Service to Reject CallsIf you subscribe to the Caller ID service, the machine detects the sender's Caller ID. If the sender's IDdoes not match the conditions specified in this setting, the machine rejects the phone call or faxreception from the sender.1. Press the FAX button, then press the Menu button.The Fax settings screen is displayed.2. Use the button to select Reception settings, then press the OK button.3. Use the button to select Caller rejection, then press the OK button.4. Use the button to select Subscribed, then press the OK button.You can now perform settings for Caller rejection.5. Use the button to select the phone call or fax rejection condition, then pressthe OK button.Set the conditions below.Anonymous numberSelects whether to reject a phone call or fax reception from a sender with no caller identification.Out of areaSelects whether to reject a phone call or fax reception out of the subscribed service area.Rejected numbersSelects whether to reject a phone call or fax reception from the numbers registered to Rejectednumbers in Fax reception reject. For details, see Rejecting Fax Reception .Reject: Rejects the phone call or fax reception matching the condition specified by this setting.If you select Reject for Rejected numbers, Register rejected no.? is displayed on the LCD. SelectYes to register a fax/telephone number to reject. For details, see Rejecting Fax Reception .Accept: Allows the phone call or fax reception matching the condition specified by this setting.NoteThis setting may not be supported depending on the country or region of purchase. Contactyour telephone company to confirm whether it provides this service.Page topPage 597 of 817 pagesUsing the Caller ID Service to Reject Calls
