Canon PIXMA MP510 Quick Start Manual

Also see for 1450B002 - PIXMA MP510 All-in-One Photo Printer: Setup instructions

Contents

Canon PIXMA MP510 Quick Start Manual Manual pdf 79 page image

75Troubleshooting*1 To resume printing, you can also press the OK button on the machine instead of selectingContinue on the camera.*2 The ink absorber absorbs ink used during cleaning, for example. If this message appears, you willneed to call for servicing to replace the absorber and to check the machine for proper operation.“Paper Error” z The Front Feeder is selected on the machine. Load the paper in the AutoSheet Feeder, press the Paper Feed Switch to select the Auto Sheet Feederas the paper source, then select Stop in the display on your camera and tryprinting again.For details, see “Changing the Paper Source” on page 11.z The paper size setting specified on the machine is not supported by yourcamera. Specify a paper size that is supported by your camera.“Paper jam” Select Stop in the display on your camera to stop printing.Remove the jammed paper, load new paper, press the OK button on themachine, and reprint.“Printer cover open” Close the Scanning Unit (Printer Cover) on the machine.“No Print Head” The Print Head is not installed or is defective.Follow the directions described in the Easy Setup Instructions to install the PrintHead.If the Print Head is already installed, remove the Print Head and then reinstall it.If the error is still not resolved, the Print Head may be damaged. Contact yourCanon service representative.“Waste tank (ink absorber*2 ) full”/“ink absorber *2 full”This error message indicates that the ink absorber is nearly full.The machine has a built-in ink absorber to hold the ink used during Print headcleaning, for example.You can continue printing by selecting Continue*1 on the display on yourcamera.However, because printing is disabled once the ink absorber becomescompletely full and until the ink absorber is replaced, you are recommended tocontact a Canon service representative as early as possible. (You will need toreplace a particular part of the machine.)“No ink” An ink tank is not installed properly, or is out of ink.Confirm the error message displayed on the LCD and take the appropriateaction to resolve the error. For details, see “Error Message Is Displayed on theLCD” on page 57.“Ink Error” An ink tank that was once empty is installed.Replace the ink tank and close the Scanning Unit (Printer Cover).Printing with an ink tank that was once empty may damage the machine.If you want to continue printing in this condition, you need to release the functionfor detecting the remaining ink level. Press and hold the Stop/Reset button forat least 5 seconds, and then release it.* With this operation, releasing the function for detecting the remaining inklevel is memorized. Please be advised that Canon shall not be liable for anymachine malfunction or damage caused by refilled ink tanks.See “Replacing an Ink Tank” on page 34.“Hardware Error” An ink tank error has occurred. Replace the ink tank. See “Replacing an InkTank” on page 34.“Printer error” An error requiring servicing may have occurred. (Machine’s POWER lampflashes green and Alarm lamp flashes orange alternately.)Disconnect the cable between the machine and the camera, turn off themachine, and unplug the power cord of the machine from the power supply.After a while, plug the power cord of the machine back in, turn on the machine,and then reconnect the camera to the machine.If the same error occurs, contact your Canon service representative.Error Message On Camera Action