Canon PIXMA MP495 Network Setup Manual

Also see for PIXMA MP495 Series: Getting started Manual Manual Network Setup Installation guide

Contents

Canon PIXMA MP495 Network Setup Manual Manual pdf 7 page image

CheckSet Up New Printer Screen is DisplayedThe screen appears when the machine cannot be detected during setup using WPS orWCN, or when setting up on an additional computer.Is the machine connected to a network?To check if the machine is connected to a network, print the NetworkConfiguration Page, then make sure that Link Status is set to Active. To printthe Network Configuration Page, press the Maintenance button 11 times todisplay the screen shown to the right, then press the Black button or the Colorbutton.•Make sure that you follow Check 1, 2, 3, 4 and 6 of "Connection Checklist" on page 11,then click Redetect.Proceed with the setup.Check 1Check 2If the machine is not connected to a network, perform setup again by following theprocedures from "6 Set Up a Wireless Connection" in the printed manual: GettingStarted.WPS Additional Computers SetupRefer to the troubleshooting tip below only when configuring wireless settings by using WPS or WCN, orwhen setting up on an additional computer.WCNGlossaryA function to allow or block traffic from network devices with specified IP addresses.IP address filtering•A function to prevent communication between multiple wireless devices (such as computers andprinters) connected to an access point.Privacy separator feature•DHCP function•A function to automatically assign required information (IP address, etc.) to computers, printers or otherdevices connected to the network.IP address•A numerical identification assigned to each computer or network device connected to a network.Is the privacy separator feature enabled on the access point?Disable the privacy separator feature.Check 5Check 4For details on how to change the settings of the access point, refer to the manual supplied withthe access point or contact its manufacturer.•For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•When obtaining an IP address automatically, make sure that the DHCP function of theaccess point is active.For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•Enable the DHCP function of the access point, then click Redetect.For details on how to change the settings of the access point, refer to the manual supplied withthe access point or contact its manufacturer.•Is the IP filtering feature enabled on the access point?Check 3For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•Set the access point to accept the IP address of the machine.For details on how to change the settings of the access point, refer to the manualsupplied with the access point or contact its manufacturer.•To check the IP address of the machine, print the Network Configuration Page,then check IP Address. To print the Network Configuration Page, press theMaintenance button 11 times to display the screen shown to the right, then pressthe Black button or the Color button.•