Chapter 10 103Troubleshooting Trouble scanning with Multi-Scan or Multi-Crop function Slow Scanning SpeedCause ActionThe original is positionedoutside the supported area.Check the position of the original on the document glass. Observe the followingwhen using the Multi-Scan or Multi-crop function.z There should be a gap of at least 0.4" / 10mm between the edge of the PlatenGlass and originals.z Leave at least 0.4" / 10mm between the originals.z A maximum of 10 originals can be scanned at once.z If an original is slightly crooked on the platen-within 10 degrees of true-theimage is automatically straightened.z The Multi-Scan function only works with rectangular originals such as photos.z Originals that are not rectangular (irregularly shaped, close-cropped photos)cannot be detected correctly.Error arising fromapplication softwarespecifications.Some application softwares do not support multiple image scanning. Scan eachitem individually without using the Multi-Scan or Multi-Crop function.Cause ActionResolution is set higherthan necessary.To view the image on a monitor, set the Output resolution to 75 dpi. To print, setthe Output resolution to a value such as 300 dpi.The descreen function is on. Turn the [Descreen] function off. (See the Scan Guide)
