Canon Microfilm Scanner 800II Instructions Manual

Also see for Microfilm Scanner 800II: Brochure & specs Brochure & specs Brochure & specs Installation guide

Contents

Canon Microfilm Scanner 800II Instructions Manual Manual pdf 25 page image

– 23 –Scanner RecognitionIf you are using Windows 98/Me/2000 or Windows XP,then the first time that you turn on your computer afterconnecting this scanner to your computer, Windows Plugand Play automatically displays a screen prompting you toinstall the scanner driver. Follow the instructions on thescreen to proceed with the installation.NOTE• The device that is detected differs depending onthe connection (SCSI or USB)• When the scanner is recognized normally, thescanner is recognized by the device manager as“CANON MS800 SCSI” regardless of the con-nection used.• When the connection to the computer ischanged, the scanner recognition may be re-quired.In the Case of Windows 98/MeWhen you are using the Windows 98/Me, only a SCSIconnection can be used. Follow the procedure below toinstall the scanner driver.● When you are using Windows 98, “CANONMS800 SCSI Scanner Device” is detected and“Add New Hardware Wizard” dialog appears.1 Click the Next button.2 Select “Search for the best driver for your device.(Recommended).” and then click the Next button.3 Load the setup disc into the computer’s CD-ROM drive.4 Select “Specify a location”, specify the following folderand then click the Next button.D:\INF (where “D” is the drive letter assigned to yourCD-ROM drive)5 Click the Next button.6 Click the Finish button.● When you are using Windows Me, “CANONMS800 SCSI Scanner Device” is detected and“Add New Hardware Wizard” dialog appears.1 Select “Specify the location of the driver (Advanced)”and then click the Next button.2 Load the setup disc into the computer’s CD-ROM drive.3 Select “Search for the best driver for your device. (Rec-ommended).” and then select “Specify a location” checkbox. Specify the folder below and click the Next button.D:\INF (where “D” is the drive letter assigned to yourCD-ROM drive)4 Click the Next button.5 Click the Finish button.Before You Begin...07.5.14, 11:06Page 23