Canon MX7600 Service Manual

Also see for PIXMA MX7600: Supplementary guide Quick start guide Setup instructions Network Setup Guide Setup instructions

Contents

Canon MX7600 Service Manual Manual pdf 12 page image

2-3. Fax ErrorsFor errors other than those listed below, please refer to the "G3 / G4 Facsimile Error Code List (Rev. 2)."(1) User error codes(2) Service error codesError code TX / RX Meaning#001 TX Document jam#003 TX / RX Document is too long, or page time-over#005 TX / RX Initial identification (T0 / T1) time-over#009 RX Recording paper jam, or no recording paper#012 TX No recording paper at the receiving machine#017 TX Redial time-over, but no DT detected#018 TX Auto dialing transmission error, or redial time-over#022 TX Call failed (no dial registration)#037 RX Memory overflow at reception of an image#085 TX No color fax function supported in the receiving machine#099 TX / RX Transmission terminated mid-way by pressing the Stop/Reset button#995 TX / RX During TX (sending): Memory transmission reservation cancelledDuring RX (receiving): Image data received in the memory clearedError code TX / RX Meaning##100 TX Re-transmission of the procedure signal has been attempted the specified number of times, but failed.##101 TX / RX Sender's modem speed does not match the receiving machine.##102 TX Fallback is not available.##103 RX EOL has not been detected for 5 seconds (or 15 seconds in CBT).##104 TX RTN or PIN has been received.##106 RX The procedure signal has been expected for 6 seconds, but not received.##107 RX Fallback is not available at the sending machine.##109 TX After DCS transmission, a signal other than DIS, DTC, FTT, CFR, or CRP has been received, and re-transmission of the procedure signal has been attempted the specified number of times but failed.##111 TX / RX Memory error##114 RX RTN has been received.##200 RX A carrier has not been detected for 5 seconds during image reception.##201 TX / RX DCN has been received in a method other than the binary procedure.##204 TX DTC has been received even when there is no sending data.##220 TX / RX System error (main program hang-up)##224 TX / RX An error has occurred in the procedure signal in G3 transmission.##226 TX / RX The stack pointer has shifted from the RAM area.##229 RX The recording area has been locked for 1 minute.##232 TX The encoder control unit has malfunctioned.##237 RX The decoder control unit has malfunctioned.##238 RX The print control unit has malfunctioned.##261 TX / RX A system error has occurred between the modem and the system control board.10 / 65