Displaying the Preview ScreenWhen you load the original on the platen glass and select Standard copy or Frame erase copy inAdvanced print, pressing a Function button allows you to preview an image of the printout on thepreview screen.When Standard copy is selected, press the left Function button on the Copy standby screen.When Frame erase copy is selected, press the right Function button on the print settings screen.ImportantThe preview screen is not available when you load the original in the ADF.In the following conditions, you cannot use the left Function button when the Copy standbyscreen is displayed.2-sided is selected for 2-sidedPrintSetting.2-on-1 copy or 4-on-1 copy is selected for Layout.ON is selected for Collate.When 2-sided, 2-on-1 copy, or 4-on-1 copy is selected and the original is loaded on the platenglass, you can set to display the preview screen after scanning the original is finished.Two-Sided CopyingCopying Two Pages to Fit onto a Single PageCopying Four Pages to Fit onto a Single PageCollated CopyingThe original will be scanned to display the preview image. Therefore, do not open the documentcover until the preview screen is displayed.Originals are rescanned after displaying the preview screen and before copying starts.Therefore, do not open the document cover or remove the original from the platen glass whileScanning document... is displayed.1. Preview of the originalThe original that is set on the platen glass is displayed. If the displayed image is skewed, refer toLoading Originals and reset the original properly, then display the preview screen again andpreview the original.2. Page sizeA frame showing the selected page size appears over the image. The inside of the frame will beprinted.3. MagnificationThe magnification setting, which was set when the preview screen was displayed, is displayed. Ifthe setting other than Fit to page is selected, you can change the magnification setting using thebutton.
