14EnConnecting via a Wired LAN1 Connect the LAN cable.The IP address will be automatically configured in 2minutes. If you want to set the IP address manually, seethe following items.User’s Guide “Network” ▶ “Connecting to a Network” ▶“Setting IP Addresses”2 Install the driver and software using the providedDVD-ROM.See “For details on the installation procedures:” (P.15).Proceed to “Setting a Paper Size and Type” on this page.Connecting via a USB CableInstall the Driver and SoftwareInstall the driver and software on the provided DVD-ROM.See “For details on the installation procedures:” (P.15).Proceed to “Setting a Paper Size and Type” on this page.NOTE• If you connected the USB cable before installing, firstremove the USB cable and then re-install.Connecting via a USB CableFollow the MF Driver Installation Guide to connect the USBcable.Proceed to “Setting a Paper Size and Type” on this page.Setting a Paper Size and TypeFollowing the instructions on the screen, set the paper sizeand type.Paper Set.HomeHome Set.Paper SaveMenuScan PC12/4Paper SettingsMP TrayDrawer 1Select Frequently Used Pape...Specifying Initial Fax Settings andConnecting a Telephone Cable1 Specify the initial fax settings.CopyHomeFaxScanMenuAddr. Book1/4Perform Fax Setup?Set Up NowSet Up LaterFollow the “Fax Setup Guide” to specify a fax number, aunit name, and a receive mode. For more details on thereceive mode, see the User’s Guide.User’s Guide “Faxing” ▶ “Confi guring Initial Settings for FaxFunctions” ▶ “Deciding Which Fax Receive Mode to Use”How to use a user nameWhen you send a document, the sender information thatyou registered is printed on the recipient’s paper.2 Connect a telephone cable.ABTelephone line connectorTelephone/Handset (Optional)When appears on thedisplay, connect the telephone cable by referring to theillustration.When installing the optional handset:For more details, see the supplied manual with thehandset.
