Canon LX-P1300 Basic Operation Manual

Also see for LX-D1300: User guide

43TroubleshootingCondition SolutionOverall appearance of the printedoutput is not satisfactory.Use dedicated paper.When paper other than dedicated paper is used the print quality maybe low. Also, it may cause paper jams and malfunctions.Verify that the paper set (size, shape, and type) matches the paper (size,shape, and type) configured by the application software or printerdriver.Set the resolution to [Input resolution 1200dpi] (prioritize imagequality) and then printRefer to “Changing Print Quality and Adjusting Color” (User's Guide).Printed paper is wavy and rubbingmarks are left on the paper.Verify that the paper set (size, shape, and type) matches the paper (size,shape, and type) configured by the application software or printerdriver.Open the [Utility] tab of the printer driver and print after setting [PreventPaper Rubbing Mode] from [Special Settings].Refer to “Changing the Special Settings of the Printer” (User's Guide).The color printed differs from thecolor on screen.Open the [Color] tab of the printer driver, and adjust the settings forimage quality and color.Refer to “Changing Print Quality and Adjusting Color” (User's Guide).Verify that the [Display] and [Screen Properties] are correctly configuredin the control panel of the computer used. Especially if the type ofdisplay or gamma factor is wrongly configured, the proper color will notbe displayed.The colors are wrong or colors mixed. Any ink tank may be installed incorrectly.If any ink tank is installed incorrectly, ink colors may be mixed. In thiscase, execute [Shipping The Printer] from the printer driver so thatremove ink from the print head. Refer to “Shipping the Printer” (User'sGuide).The back side of the paper gets dirty. When printed with the wrong paper size, the paper guide or transportarea may become dirty. Confirm that the size of the paper set and the[Paper Size] configured by the application software or printer driver arethe same.If the paper guide or transport area is dirty, Clean the transport unit.Refer to “Cleaning the Printer” (User's Guide).