Canon ImagePrograf iPF840 series Basic Manual

Also see for imagePROGRAFi iPF840 series: Setup guide User guide Quick guide

Contents

Canon ImagePrograf iPF840 series Basic Manual Manual pdf 128 page image

Insufficient paper for jobInsufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount of roll paper left when Manag-eRemainRoll in the Control Panel menu is On.Press ▲ or ▼ to select Print, andthen press the OK button to resumeprinting.However, the roll paper may run outduring the print job and you may notbe able to print all of the document.Press ▲ or ▼ to select Change Pa-per, and then press the OK button tostop printing.(See "Removing the Roll from thePrinter.") ➔ P.21(See "Loading Rolls in the Print-er.") ➔ P.15Press ▲ or ▼ and select Stop Print-ing or press the Stop button to stopprinting.This paper cannot be used as size is not supported.This paper cannot be used as size is not supported.Cause Corrective ActionPaper that is too large for the printer has beenloaded.Lift the Release Lever and load paper of the correct size.(See "Paper Sizes.") ➔ User's GuidePaper that is too small for the printer has beenloaded.Lift the Release Lever and load paper of the correct size.(See "Paper Sizes.") ➔ User's GuidePaper has been loaded that is too small toprint the test pattern for printhead adjustmentor nozzle checking.Lift the Release Lever and load unused paper A4/Letter (vertical) or larger. Morethan one sheet may be required depending on the adjustment.Cannot print as selected. Another roll is in use.Cannot print as selected. Another roll is in use.Cause Corrective ActionA printed document remains in the Output Tray without being cutand a print job was received that specifies the other roll.Press the OK button to stop printing.Cut the printed document.(See "Specifying the Cutting Method for Rolls.") ➔ User's GuideLoad the other roll and resend the print job.(See "Loading and Printing on Rolls.") ➔ User's GuideRoll printing is selected.Roll printing is selected.Cause Corrective ActionYou have attempted to print on a roll,but no roll is loaded.Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll,and then print.(See "Attaching the Roll Holder to Rolls.") ➔ P.12(See "Loading Rolls in the Printer.") ➔ P.15Press ▲ or ▼ and select Stop Printing or press the Stop button to stop printing.Roll printing is selected, but sheets are loaded.Roll printing is selected, but sheets are loaded.Cause Corrective ActionA print job for rolls was received when asheet is loaded.Follow these steps to load and print on a roll.1. Press ▲ or ▼ to select Eject Cut Sheet, press the OK button, and remove the sheet.(See "Removing Sheets.") ➔ P.282. Load a new roll.Insufficient paper for job iPF840 SeriesBasic GuideError Message Messages regarding paper128