Canon Finisher-R1 Installation Procedure

Also see for Finisher-R1: INSTALLATION PROCEDURE Circuit Diagram General Timing Chart/General Circuit Diagram Service manual Service manual

Contents

Canon Finisher-R1 Installation Procedure Manual pdf 26 page image

Chapter 1181.4 Making Adjustments1.4.1 Adjusting the Height/Tilt 0003-1769If the height or the tilt of the finisher and the host machine is not as indicated, go through the following steps tomake an appropriate correction:■ Preparing for Adjustment

In the case of the Finisher-R1, you will need to remove its auxiliary ring and rear foot cover. Be sure to removethe auxiliary ring with the finisher and its host machine intact, thus preventing the machine from tumbling over.1) If you need to adjust the height at the rear, remove the 4 screws [1], and detach the auxiliary plate [2].2) Remove the 2 screws [3], and detach the left rear foot cover [4].F-1-313) From the back of the removed front cover, remove the fixing screw, and detach the pliers [1].[3][4][1][1][2]