401With a commercially-available Eye-Fi card already set up, you canautomatically transfer captured images to a computer or upload them toan online service via a wireless LAN.The image transfer is a function of the Eye-Fi card. For instructions onhow to set up and use the Eye-Fi card or to troubleshoot any imagetransfer problems, refer to the Eye-Fi card’s instruction manual orcontact the card manufacturer.The camera is not guaranteed to support Eye-Fi cardfunctions (including wireless transfer). In case of an issuewith an Eye-Fi card, please check with the card manufacturer.Also note that approval is required to use Eye-Fi cards inmany countries or regions. Without approval, use of the cardis not permitted. If it is unclear whether the card has beenapproved for use in your area, please check with the cardmanufacturer.1 Insert an Eye-Fi card (p.31).2 Select [Eye-Fi settings].Under the [51] tab, select [Eye-Fisettings], then press <0>.This menu is displayed only when anEye-Fi card is inserted into thecamera.3 Enable Eye-Fi transmission.Select [Eye-Fi trans.], then press<0>.Select [Enable], then press <0>.If you set [Disable], automatictransmission will not occur even withthe Eye-Fi card inserted(transmission status icon I).H Using Eye-Fi Cards