Manual Connection by Searching Networks1164 Select [Find network].Press the <V> key to select [Findnetwork], then press <0>.Select [OK] and press <0> to go tothe next screen.5 Select an access point.Press <0> to enable the selection ofan access point.Press the <V> key to select anaccess point, then press <0>.Select [OK] and press <0> to go tothe next screen (p.117).(1) Indicates that the device is in infrastructure mode(2) An icon is displayed if the access point is encrypted(3) First characters of the SSID(4) Channel usedAccess Point EncryptionThis camera supports the following options for [Authentication] and[Encryption settings]. Therefore, the encryption used by the accesspoint should be one of the following.[Authentication]: Open system, Shared key, WPA-PSK, or WPA2-PSK[Encryption settings]: WEP, TKIP, or AES[Enter connection] and [Search again]To configure settings for the access point manually, select [Enterconnection] and press <0>. Enter the SSID using the virtualkeyboard and then configure settings following the instructionsdisplayed.To search for access points again, select [Search again] and press<0>.(1) (2) (3) (4)COPY