|
Chapter 22-22) Make the following selections to highlight [SENS-IN]; FEEDER>FUNCTION>SENS-IN.3) Press the OK key.In response, the machine will run an automaticadjustment session, and will indicate 'OK!' if it endsnormally.4) When done, end service mode.2.1.4 Tray Width 0003-3042To adjust the tray width, go through the stepsunder either "1. AB-Configuration" or "2. Inch-Configuration."1. AB-Configuration1) Turn on the host machine, and start its servicemode.Press the User Mode key; press the 2 and 8 keys at thesame time; then, press the User Mode key onceagain.2) Touch the following in sequence on the screen tobring up the Adjustment screen:FEEDER>FUNCTION>TRY-A4.3) Move the tray side guide to the index A4/A3.4) Press the OK key to register the A4 width.5) Move the tray side guide to the index A5R.6) Touch [TRY-A5R] to highlight.7) Move the tray side guide to the index A5R.8) Press the OK key to register the A5R width.9) Press the Reset key twice to end service mode.10) Turn off the host machine's control panel powerswitch and main power switch in sequence.11) Turn on the host machine's main power switch.2. Inch-Configuration1) Turn on the host machine, and start its servicemode.Press the User Mode key, and press the 2 and 8 keysat the same time; then, press the User Mode keyonce again.2) Touch the following in sequence on the screen tobring up the Adjustment screen:FEEDER>FUNCTION>TRY-LTR.3) Move the tray side guide to the index LTR/11x17.4) Press the OK key to register the LTR width.5) Touch [TRY-LTRR] to highlight.6) Move the tray side guide to the index STRM/LTRR/LGL.7) Press the OK key to register the LTRR width.8) Press the Reset key twice to end service mode.9) Turn off the host machine's control panel powerswitch and main power switch in sequence.10) Turn on the host machine's main power switch.2.1.5 Eliminating the Tilt 0003-1846Be sure you have adjusted the angle of the ADFbefore starting the following adjustment:1) Loosen the nut [1] found at the rear of the left hinge;then, turn the hex bolt [2] so that the fixing member[3] is as far as the line marking [4].- turn the bolt clockwise to move the member ahead.- turn the bolt counterclockwise to move the memberin reverse.2) Tighten the nut.
|
