Canon Creative Park Aassembly Instructions

Also see for creative park: Service manual

Potala Palace, China : Assembly InstructionsA. Red Palace / White PalaceBefore starting assembly :Writing the number of each section on its back side beforecutting out the sections is highly recommended.(* This way, you can be sure which section is which evenafter cutting out the sections.)Indicates where sections shouldbe glued together.Assembly InstructionsMountain fold(dotted line)Make a mountain fold.Valley fold(dashed and dotted line)Make a valley fold.Scissors line(solid line)Cut along the line.Cut in line(solid line)Cut along the line.Glue spot(Red dot)Glue parts with the same number together.Glue spot(Green dot)Glue within the same part.Glue spot(Blue dot)Glue to the rear of the other part.GlueThe glue spot(colored dot)shows where to apply the glue.Tools and materialsAssembly tipCautionScissors, set square, glue(We recommend stick glue), pencil, usedballpoint pen, toothpicks, tweezers, (useful for handling small parts)Before gluing, crease the paper along mountain fold and valleyfold lines and make sure rounded sections are nice and stiff.Glue, scissors and other tools may be dangerous to young childrenso be sure to keep them out of the reach of young children.View of completed modelAssembly Instructions : Forty five A4 sheets (No. 1 to No. 45)*Hint: Trace along the folds with a rulerand an exhausted pen (no ink) to get a sharper, easier fold.* Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.* This model was designed for Papercraft and may differ from the original in some respects.NarrowWideAssemble in the direction shownin the illustration.