Canon CanoScan 9000F Mark II Quick Start Manual

Also see for CanoScan 9000F Mark II: Quick start guide Quick start guide

Canon CanoScan 9000F Mark II Quick Start Manual Manual pdf 1 page image

August 2018 1www.ed.ac.uk/is/ucreateIS.Helpline@ed.ac.ukReplacing the cover after use:slide the tabs at the bottom ofthe cover into the slot in the lidbefore securing the clip at the topThe clip at the top of the innercover which secures it to theunderside of the scanner lidScan film with the CanonCanoScan 9000F Mark II1 When using the Canon scanner to scan film or slides, make sure the cover which fits under thescanner lid is removed.The cover’s securing mechanism is fragile so remove it very carefully by gently pressing the clipat the top of the cover down and towards you.Please replace the inner cover when you are finished scanning by slotting the tabs at the bottomof the inner cover into the lower part of the scanner lid then pressing gently on the clip at the top tosecure it.For the care of your film and the scanner glass, it is important that your handsare clean before commencing and that you avoid touching the scanner glass.It is also important to avoid touching the image area of your film, as anysmall dirt specks or fingerprints will become magnified when the images arescanned at high resolution.Note: If you encounter an error message when attempting a scan using any uCreatescanner, please consult the Troubleshooting section on page 5.

/ 5

Related manuals for Canon CanoScan 9000F Mark II