Menu
Canon CS100 Instruction Manual
Also see for CS100: Get started
                                                                            | |
23J Importing from a CardImport images by inserting a card storing captured images into Connect Station.Images can be imported from a card used for shooting with Canon compact digitalcameras, digital single-lens reflex cameras, compact system (mirrorless)cameras, or digital camcorders released in 2010 or later. Although images may beimported from a card used in other cameras, there is no guarantee for the importof images to Connect Station.Compatible cardsThe following cards can be used when importing images from a card.SD/SDHC/SDXC memory cardCF (Compact Flash) card* The CFast card is not supported.When holding the camera/camcorder close to Connect Station, do not drop thecamera/camcorder on it or push the camera/camcorder hard against it. Doing so maydamage the built-in hard disk.While images are being imported, you cannot connect an NFC-compatible camera/camcorder even if you hold it close to Connect Station.If a case etc. is attached to the camera/camcorder, connection may not be possible. Insuch a case, detach the case etc., and hold the camera/camcorder close to ConnectStation.Since the camera/camcorder may not be recognized readily, carefully hold the camera/camcorder close to the NFC connect point on Connect Station while rotating thecamera/camcorder horizontally.Just holding the camera/camcorder close to Connect Station may not establish aconnection. In such a case, gently touch Connect Station with the camera/camcorder.When connecting Connect Station to a camera/camcorder, and it gives three shortbeeps and the power lamp blinks in red, this indicates that Connect Station is not in astatus to establish connection. Make sure if the camera/camcorder is ready forconnection.If the camera/camcorder and Connect Station are moved too far away from each otherwhile importing images, the import may take time or the connection may be terminated.If the camera’s/camcorder’s battery runs out during import, the import will stop. Chargethe battery, then try importing again.While a wireless LAN connection is established, you may not be able to connect acamera/camcorder even if you connect it with an interface cable.The power to some cameras/camcorders may be turned on when you hold thecamera’s/camcorder’s n close to Connect Station.When all images are already imported, import does not start. |
Related manuals for Canon CS100
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved