Canon BW UFRII LT PRINTER KIT-J2 Service Manual

Also see for UFRII LT PRINTER KIT-J2: INSTALLATION PROCEDURE INSTALLATION PROCEDURE

Contents

Canon BW UFRII LT PRINTER KIT-J2 Service Manual Manual pdf 32 page image

Chapter 33-4F-3-98) Put back the machine's rear cover you removed in step 2).9) Connect the user's LAN cable to the machine.F-3-1010) Connect the power plug to the power outlet, and turn on the main power switch.3.2.2 Checking the Connection 0010-7517At the end of the work, go through the following steps to make sure that the machine properly recognizes the presence of the unit:1) Start service mode.User Mode key >2 > 8 > User Mode key[#SSSW] appears.2) Press [<-] 5 times. When [REPORT] has appeared, press [OK].3) Press [+>] once. When [REPORT OUTPUT] has appeared, press [OK].4) Press [+>] 5 times. When [SPEC LIST] has appeared, press [OK].5) See that a SPEC REPORT is printed out. Check to be sure that 'BDL-IMAGE' is 'ON'.MEMO:"SPEC REPORT"- If 'TOTAL MEMORY' is 128 MB,be sure 'BDL-IMAGE (600)' is 'ON'.- If 'TOTAL MEMORY' is 256 MB,be sure 'BDL-IMAGE (1200)' is 'ON'.[1][2][3]

/ 34

Related manuals for Canon UFRII LT PRINTER KIT-J2