Advanced Guide > Troubleshooting > Machine Moves But Ink Is Not EjectedMachine Moves But Ink Is Not EjectedCheck 1: Are the Print Head nozzles clogged?Print the Nozzle Check Pattern to determine whether the ink ejects properly from the print headnozzles.Refer to Routine Maintenance for the Nozzle Check Pattern printing, Print Head Cleaning, and PrintHead Deep Cleaning.If the Nozzle Check Pattern is not printed correctly:Check to see if a particular color's ink tank is not empty.If the Nozzle Check Pattern is not printed correctly though ink is sufficient, perform the Print HeadCleaning and try printing the Nozzle Check Pattern again.If the problem is not resolved after performing the Print Head Cleaning twice:Perform the Print Head Deep Cleaning.If the problem is not resolved after performing the Print Head Deep Cleaning, turn off themachine and perform another Print Head Deep Cleaning after 24 hours. When you turn themachine off, do not unplug it from the power supply.If the problem is not resolved after performing the Print Head Deep Cleaning twice:If Print Head Deep Cleaning does not resolve the problem, the Print Head may be damaged.Contact the service center.Check 2: Has the ink run out?See An Error Message Is Displayed on the LCD to identify the ink error, and then take theappropriate action depending on the error condition.Check 3: Is the orange tape or protective film remaining?Make sure that all of the protective film is peeled off and the air hole is exposed, as illustrated in (A).If the orange tape is left as in (B), pull the orange tape and remove it.Page topPage 854 of 997 pagesMachine Moves But Ink Is Not Ejected
