Canon 0273B001 - Elura 90 Camcorder Instruction Manual

Also see for 0273B001 - Elura 90 Camcorder: Software guide Instruction manual Instruction manual

Contents

Canon 0273B001 - Elura 90 Camcorder Instruction Manual Manual pdf 16 page image

16 Connecting the Camcorder to a ComputerConnecting the Camcorder to a Computer Make sure the camcorder is being powered using the power adapter beforeconnecting it to a computer. Be sure to install the Digital Video Software before you connect thecamcorder to the computer. Connect the USB cable directly to one of the computer’s main USB ports.The interface may not function correctly if the camcorder is connected via aUSB hub. The connection may not operate correctly if you are using other USBdevices, excluding USB mice or keyboards, at the same time. If this occurs,disconnect the other devices from the computer and try reconnecting thecamcorder. Do not connect two or more camcorders to the computer. The camcordersmay not operate normally. Never allow the computer to go into standby (sleep) mode while acamcorder is connected via the USB interface. Refer to your computer manual for the location of the computer’s USB ports. See your camcorder instruction manual for connecting instructions.1 Insert a memory card containing images into the camcorder.2 Connect the power adapter to the camcorder.3 Turn the POWER switch to PLAY (VCR) and move the TAPE/CARD switch to CARD.Wait until the card access indicator stops flashing.4 Attach the supplied USB cable to the computer’s USB portand the camcorder’s USB Terminal.• The first time you connect the camcorder to the computer:- Installation of the DV TWAIN Driver (Windows 98/Windows 2000) or the DVWIA Driver (Windows Me) starts.- If the “Digital signature not found” message appears, click [Yes].- After a few moments, a message such as “New Hardware Found” appearsand the driver will be installed automatically.- If you are prompted to restart the computer, restart the computer.• Windows 98/Windows 2000/Windows XP: A window appears allowing you toselect an application program to start.Windows Me: The Scanners and Cameras Wizard starts. Click [Cancel] toclose the Wizard.