OneStart

Menu

Canford MINX MIXER Operating Instructions Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Contents
  1. technical data
  2. Table Of Contents
  3. Introduction
  4. High Pass Filter
  5. Limiter
  6. Control Line Input
  7. Fuse Holder
  8. Phantom Power (obsolete version)
  9. Technical Specifications
Canford MINX MIXER Operating Instructions Manual Manual pdf 9 page image
02-406 (Issue 1) 01/03 MINX MIXER - OPERATING INSTRUCTIONS- 9 -TECHNICAL SPECIFICATIONInputNoise Referred to InputMeasurement Method Mic Line Output Noise22Hz to 22KHz RMS -121.1dB -79.7dB -75.0dBA weighted RMS -124.7dB -82.3dB -78.1dBCCIR weighted RMS -117.9dB -73.4dB -69.0dBCCIR weighted quasi peak -112.1dB -69.3dB -65.1dBCCIR/ARM ref 2kHz -122.8dB -80.0dB -75.7dBHarmonic Distortion <0.1% at 1KHzImpedance Mic > 1K ohm floating(Both transfer bal.) Line > 10K ohm bridgingSensitivity -70dBm to - 40dBm (Mic)(Fader fully open) -20dBm to + 10dBm (Line)Headroom at Inputs Mic better than 30dB(Fader fully open) Line better than 20dBAmplitude-frequency response(w.r.t. 1KHz) 40Hz – 15KHz ±1.0dB125Hz – 10KHz ± 0.5dBHi-pass filter -3dB at 80Hz Slope = 6dB/octaveWiring ConventionsXLR - Type connectors: Pin 1 = GroundPin 2 = +ve Phase or ‘Hot’Pin 3 = -ve Phase or ‘Cold’RCA Phono connectors: Tip = +ve Phase or ‘Hot’Ring = -ve Phase or ‘Cold’1/4” Jacks connectors Tip = +ve Phase or ‘Hot’Ring = -ve Phase or ‘Cold’Sleeve = GroundBare wire terminals: Red = +ve Phase or ‘Hot’Black = -ve Phase or ‘Cold’CANFORD AUDIO PLCCROWTHER ROAD WASHINGTONTYNE & WEAR NE38 OBW, UKadmin (0191)418 1000sales (0191)418 1122fax (0191)418 1001 technical data
/ 9
This manual is suitable for:
MINX MIXER
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved