The water removed from the laundry during thedrying cycle is collected in a container at thebottom of the dryer.When the container is full the indicator onthe control panel will light, and the containerMUST be emptied. However, we recommend thatthe container is emptied after each drying cycle.NOTE: Very little water will collect during thefirst few cycles of a new machine as an internalreservoir is filled first.To remove the container1. Gently pull the bottom of the kickplate sothat it unclips from the dryer. The topsection can then be unhinged allowing thekickplate to be completely removed.2. Pull firmly on the handgrip and slide thewater container out of the dryer.Support the container with both hands. Whenfull, the water container will weigh about 4kg.3. Open the lid located on the top of thecontainer and empty the water.4. Refit the lid and slide the water containerback into position. PUSH FIRMLY INTOPLACE.5. Refit the kickplate by engaging the hingesat the top and 'snapping' the lower clipsinto place.13Water Container40003485Eng.qxd 06/07/2005 10:25 Page 13