30During drying phase the drum will accelerate to a higher speed to distribute the loadand to optimize the drying performancePlug not in socket.Not switched on.Power failure.Fuse blown.Door open.See cause 1.Tap turned off.Programme selector not correctly positioned.Fill hoses are kinkedKink in discharge hose.House drain is blockedOdd material blocking filterLeaking gasket between tap and water inlethose.House drain is blockedSoap drawer blocked with soap residuesWater has not yet drained away."No spin" selected (certain models only).Washing machine not completely level.Transit brackets not removed yet.Load not distributed evenly.Two minutes have not elapsed since theprogramme finished.–No water fill.No pump out.Machine overfilled with water.1. Does not work on anyprogramme2. Does not fill with water3. Water does not drain away4. Water on floor around thewashing machine5. Does not spin6. Machine vibrates a lotduring spin7. Door will not open8. Display reads error0, 1, 5, 7, 8, 99. Display reads error 210. Display reads error 311. Display readserror 4Plug it in.Switch on.Check.Check.Close door.Check.Turn on tap.Position programme selector correctly.Straighten fill hosesStraighten discharge hose.Clean drainCheck filterReplace gasket and tighten hose and tapwell.Clean drainClean soap drawerWait a few minutes for machine to empty.Reset button or turn "no spin" knob.Adjust the special adjustable feet.Remove transit brackets.Rearrange the laundry evenly.Wait two minutes.Call service.Check water supplies are on.Check drain is clear.Check drain hose is not kinked.Turn off water supply to machine.Call service.Investigating malfunctionsWhat might be the cause of…Defects you can remedy yourselfMALFUNCTION CAUSE REMEDYThe machine makes adifferent noise whenspinning! This is because ithas a brush motor for betterperformance.Only a small level of water can beseen in the drum! This is becausenew machines do not use muchwater, yet achieve the same standardof washing and rinsing.