Menu
Canary Products MMRC190 Instruction Manual
   |
Model # MMRC190INFRARED REMOTE CONTROL MIST MAKERINSTRUCTIONS MANUALThank you for purchasing Canary Products. Please read the instructions manualcarefully before operating.FEATURES & FUNCTIONS MMRC192 has both inline control and remote control You can use both the inline and remote control to select the colorof your choice. Or you can simply turn off the color if you choose to do so. You also have the option of controlling the amount of mist itproduces: low-medium-highPlease see the complete instruction for use of the remote and inlinecontrol below.TECHNICAL DATAWorking Voltage(VAC)Working ElectricCurrent (A)UltrasonicFrequency(KHz)Ceramic discspec. (mm)24 0.60~ 0.70 1700±40 Φ20Generate mist(ml/h)Water temp. Range( ℃ )Lifespan of CeramicDisc ( hour)≥250 15 ~ 50 >2000OPERATING PROCESS1. Place the MIST MAKER into a water container.2. The water level sensor switch (please see drawing 1), must be completelysubmerged under water (about 1/4 –1/2 inch is optimal). If submerged any furtherthan ½ inch than the mist will not work optimally.3. Connect the mist maker with the inline control.4. Connect the inline control with the adapter.5. Plug in the adapter into your outlet.6. If there is no mist or the LED lights are not operating, please note that you do nothave enough water, as it is not submerged completely.NOTICE & CAUTION1.Please DO NOT hold or pick up the fogger unit with its water level sensor. DONOT scratch or bump the water-level sensor as it could permanently damage theunit.2. Don't move the fogger unit or pull its cable while it's working.3. Don't put your hand above the ceramic disc of the mist maker. The vibration canshock you, but it is not an electronic shock.MAINTENANCE & SERVICEa. Be sure to pour clean and filtered water and replace water in the glass bowl timely.b. Clean the ceramic disc and the surface of the mist maker with soft cloth or cottonsticker in clean water once a month. DO NOT touch or scratch the ceramic disc orthe water lever sensor switch. DO NOT use washing powder to clean any part ofthe mist maker.c. If the unit cannot generate mist after running for some time, please check andconfirm there is enough water in the bowl. If the LED light is also off and notcreating mist, please make certain that it is receiving electricity and check the onand off switch.d. If the unit cannot generate mist, but only spraying water, the unit is good, the waterin the bowl may be dirty. Simply replace the water in the bowl, it should startworking normally. If it continues to spray, but not mist, please make sure the levelof the water is not higher than ½” above the water level sensor.e. After running some time (approximately 1500 hours), the mist will start to reduce. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved