Camsat CDS-6IPeco Quick Start-up

Also see for CDS-6IPeco: User manual

Camsat CDS-6IPeco Quick Start-up Manual pdf 1 page image

TECHNICALSUPPORTtel.+48 52 387 36 58Mon–Fr 8.00 AM–4.00 PMEconomic wireless image and soundtransmission system for IP cameras HD and UHD inthe band 5.1 - 5.8 GHz.QUICK START-UPLINK INFORMATIONIt contains basic information about the settings of the radio eg. the name of the radio link,signal strength and a list of connected radio transmitters.CAMERA CONNECTION SETTINGSWireless - Contains settings such as radio link eg.transmission type (Master / Slave),operating channel frequency, the name of the link SSID, signal strength, transmission coding.Network Settings – Contains settings for IP networks1. Menu Structure - website panelTime Zone Setting - set the time, the NTP serverSystem Log - an overview of recent developments and changes in the device CDS-6IPecoUpgrade Firmware - Software UpdateBackup/Restore - save / restore configuration systemADVANCED SETTINGS6. The recommended configuration settings:a) Change the password to log on to the web panel (ADVANCED SETTINGS / PASSWORD).b) Enter the radio transmission encryption password - a recommended coding WAP2-PSK(CAMERA CONNECTION SETTINGS / WIRELESS).c) Scan free channels - set Receiver the operating mode Slave. Save and press MastersScan to scan the busy channels.With this information, you will learn which channels in a given area are free or the leastbusy. In the lack of available operating channels is allowed to set multiple radios on thesame channel, then choose a channel of the weakest signal (below <-65dB).7. Test the radio link.The last step is to check the correctness of transmission between devices.To check the information about connected CDS-6IPeco devices such as powersignal, connection time, speed, IP address, etc. you must enter the LINK INFORMATION.To view an updated list of current connections, click the Refresh button at the bottomor press F5. The presence of transmitters MAC addresses list in the receiver indicatesthe correctness of the radio configuration. To be sure disconnect transmitting unit fromthe computer and connect the IP camera.If the devices communicate with receiver it means that the radio connection isproperly configured and running. In the browser's address bar enter the IP addressof the camera and check the quality of image transmission. You can start to assemblyunits at the facility.These steps must be repeated for each individualtransmitting / receiving unit subsequently connecting them to your computer.EUEUPOLISHMARKPOLISHMARKPassword - changing the passwordNewest processor 4K and UHD resolution Small sizeLow powerconsumptionHigh powertransmissionFull instructions can be found at: http://camsat.com and on the CDFull instructions can be found at: http://camsat.com and on the CD

/ 2

Related manuals for Camsat CDS-6IPeco