Campbell UT10 Insrtuction Manual

Also see for UT10: Product manual Instruction manual Product manual

Contents

Campbell UT10 Insrtuction Manual Manual pdf 20 page image

UT10 Weather Station2.2.1.2 019ALU CrossarmAttach the 019ALU crossarm to the mast as shown in FIGURE 2-9.2. Position the middle NU-RAIL so that it rests on top of the bell reducer.Orient the 019ALU in a East/West direction, with the 3/4 in NU-RAILfacing East and tighten the set screws. If the 019ALU is used with the 025Crossarm Stand (Section 2.2.4), orient the 019ALU North/South, with the3/4 in NU-RAIL facing South.3. Install the lightning rod to the mast as shown in FIGURE 2-9. Loosen thetwo screws on the lightning rod mounting bracket. Position the mountingbracket 2 in down from the top of the mast and tighten both screws evenly.Make sure the lightning rod set screw is tight.2.2.2 Gill Radiation Shields (41303-5A, 41003-5, 41005-5)1. Attach the radiation shield to the tower leg, tower mast, or CM202,CM203, CM204, or CM206 crossarm with the u-bolt and nuts provided. Ifattaching to the tower leg or mast, place u-bolt in the radiation shield’sside holes. If attaching to a crossarm, place the u-bolt in the radiationshield’s bottom holes.FIGURE 2-7. Top View of TowerNorth12