Campbell Hausfeld IN717702AV Operating Instructions Manual

Contents

Campbell Hausfeld IN717702AV Operating Instructions Manual Manual pdf 6 page image

6Operating Instructions SB504000www.chpower.comOperating Instructions(Continued)ADJUSTING THE DIRECTION OF THEEXHAUSTThe tool is equippedwith an adjustabledirection exhaustdeflector. This isintended to allowthe user to changethe direction of the exhaust. Simplytwist the deflector to any directiondesired.User - MaintenanceInstructionsCLEARING A JAM FROM THE TOOL1. Disconnect the airsupply from the tool.2. Remove all nails fromthe magazine (seeLoading/ Unloading).Failure to do so willcause the nails toeject from the front of the tool.3. Loosen cap screws on nose of tool.Slide nose downward and removefrom tool to expose jammedfastener.4. Reinstall nose assembly in reverseorder in Step #3.5. Make sure the trigger and WorkContact Element (WCE) move freelyup and down without sticking orbinding.TECHNICAL SERVICEPlease call our Tool Hotline at 1-800-543-6400 with any questions regardingthe operation or repair of this tool orfor additional copies of this manual.FASTENER AND REPLACEMENTPARTSUse only genuineCampbell Hausfeld18 gauge fasteners (or equivalent - seeFastener Interchange Information).Tool performance, safety and durabilitycould be reduced if improper fastenersare used. When ordering replacementparts or fasteners, specify by partnumber.TOOL REPAIROnly qualified personnel should repairthe tool and they should use genuineCampbell Hausfeld replacement partsand accessories, or parts and accessorieswhich perform equivalently.ASSEMBLY PROCEDURE FOR SEALSWhen repairing a tool, the internalparts must be cleaned and lubricated.Parker O-lube or equivalent must beused on all o-rings. Each o-ring must becoated with O-lube before assembling.A small amount of oil must be used onall moving surfaces and pivots. Afterreassembling, a few drops of 30Wnon-detergent oil or equivalent, mustbe added through the air line beforetesting.STORAGEThe tool should be stored in a cool dryplace.Rotate