Campbell Hausfeld IN629500AV Operating Instructions And Parts Manual

Campbell Hausfeld IN629500AV Operating Instructions And Parts Manual Manual pdf 11 page image

LoCAtIonWhen assembled, the tank must sit level to allow the tank to drain properly.It is extremely important to install the compressor in a clean, well ventilated area wherethe surrounding air temperature will not be more than 100°F.A minimum clearance of 18 inches between the compressor and a wall is requiredbecause objects could obstruct air flow.Do not locate the compressor air inlet near steam, paint spray, sandblastareas or any other source of contamination. This debris will damage themotor.WheeL LoCk/Foot brAkeTo move the compressor, use your foot to lift the foot brake lever to disengage thebrake.Once the compressor is at the desire location, use your foot to push down on the footbrake lever to engage the brake.eLeCtrICAL InStALLAtIonAll wiring and electrical connections should be performed by a qualifiedelectrician. Installation must be in accordance with local codes andnational electrical codes.Never use an extension cord with this product. Use additionalair hose instead of an extension cord to avoid power loss andpermanent motor damage.grounDIng InStruCtIonS1. This product is for use on a nominal 120 volt circuit and has a grounding plug thatlooks like the plug illustrated in Figure 12. Only connect the product to an outlethaving the same configuration as the plug. Do not use an adapter with this product.In the event of an electrical short circuit, grounding reduces risk of electrical shockby providing an escape wire for electric current. This product is equipped with acord having a grounding wire with an appropriate grounding plug. Plug must beplugged into an outlet that is properly installed and grounded in accordance withall local codes and ordinances.Improper use of grounding plug can result in a possible riskof electrical shock!Do not use a grounding adapter with this product!2. If repair or replacement of cord or plug is necessary, do not connect grounding wireto either flat blade terminal. The wire with insulation having an external surfacethat is green (with or without yellow stripes) is the grounding wire.Never connect green (or green and yellow) wire to a live terminal.3. Check with a qualified electrician or serviceman if grounding instructions are notcompletely understood, or if in doubt as to whether product is properly grounded.Do not modify plug provided; if it will not fit outlet, have proper outlet installed by aqualified electrician.11www.chpower.comSTOP!WL6700 SeriesInstallationTEST RESETFigure 12 - grounding methodFigure 11 - Wheel Lock/Foot brakeDisengagedEngaged