Campbell ET107 Product Manual

Also see for ET107: Instruction manual Product manual

Contents

Campbell ET107 Product Manual Manual pdf 70 page image

6. Take one black wire tie and strap the antenna cable to the antenna. Leave some slack onthe cable between the wire tie and the antenna connector so as not to stress theconnector/cable connection.7. Wire tie the antenna cable to the pole. Clean up the wire ties and put the cable cover backon.8. Refer to the NL241 user manual for setting information to establish communication(https://s.campbellsci.eu/documents/eu/manuals/nl241.pdf)6.8 Lightning rod installationInstall lightning rod as shown in FIGURE 6-40 (p. 58) and FIGURE 6-41 (p. 59).1. Carefully mount the lightning rod clamp to the top of the pole (FIGURE 6-40 (p. 58)).Position the clamp so it won’t interfere with the connector cover.FIGURE 6-40. Lightning rod bracket installation2. Strip 2.5 cm (1 in) from the top of the main green 10 AWG pole ground wire.3. Insert the exposed wire into the empty clamp opening. Do not tighten the screw at thistime (FIGURE 6-41 (p. 59)).Section 6. Installation 58