Campbell BaroVUE 10 Quick Deploy Manual

Also see for BaroVUE 10: Product manual

Campbell BaroVUE 10 Quick Deploy Manual Manual pdf 1 page image

04/2021www.campbellsci.com/barovue101. IntroductionThis Quick Deploy Guide provides an overview of the stepsused to install and measure the BaroVUE 10 using SDI-12. Theproduct manual is the definitive source for detailed installationinstructions and information. The manual is available at:www.campbellsci.com/barovue10 .2. Program sensor1. Connect the data logger to the computer.2. Open Short Cut and click Create New Program.3. Double-click the data logger model.4. In the Available Sensors and Devices box, typeBaroVUE10 or find the sensor in the Sensors >Meteorological > Barometric Pressure folder, anddouble-click BaroVUE10 (SDI-12) Barometric PressureSensor. SDI-12 Address defaults to 0. Enter the correctSDI-12 Address for the sensor if it has been changedfrom the factory default value. Type the elevation inmeters. Choose whether to measure the sensor everyhour or every scan. The Barometric pressure andTemperature default to hPa and deg C, respectively.These can be changed by clicking the Barometricpressure or Temperature box and selecting anotheroption.5. Click the Wiring tab to see how the sensor is to be wiredto the data logger. The default control terminal forSDI-12 is C1. To change to another terminal, click theterminal name and select another terminal. Click OKafter wiring the sensor.6. In Output Setup, type the scan rate, a Table Name, andData Output Storage Interval. Click Next.

/ 3

Related manuals for Campbell BaroVUE 10