Cameo PIXBAR DTW PRO User Manual

Cameo PIXBAR DTW PRO User Manual Manual pdf 6 page image

6DMXITALIANOPOLSKIESPAÑOLFRANCAISDEUTSCHENGLISHOPERATIONPLEASE NOTE• As soon as the spotlight is correctly is connected to the power supply, the following will be displayed in succession: “Update Wait...” (only forservice purposes), “Welcome to Cameo”, the model name and the software version. After this process, the lamp is ready for operation and startsin the previously selected mode.• If the DMX or slave operating mode is activated and there is no control signal at the DMX input, the display will start to flash after a few seconds.• After approximately 30 seconds of inactivity, the display will automatically show the currently active operating mode.• Press MODE to go up one level in the menu structure.CONFIGURE DMX START ADDRESSPress the MODE button repeatedly until “Menu” is displayed on the top line of the display. Use the UP and DOWN keys to select the menu item“DMX Address” and press ENTER. Using the UP and DOWN buttons, configure the desired DMX start address and press ENTER to confirm. TheDMX mode will start simultaneously.Menu structureMenuDMX AddrENTERUP/DOWNDMX Addr001 – DMX Addr512 ENTERCONFIGURING DMX MODE (DMX Mode)Press the MODE button repeatedly until “Menu” is displayed on the top line of the display. Use the UP and DOWN keys to select the menu item“Menu DMX Mode” and press ENTER. Now select the desired DMX operating mode with the buttons UP and DOWN and confirm with ENTER.Comprehensive DMX tables can be found in these instructions under “DMX CONTROL”.Menu structureAmber - WW - CWMenuDMX ModeENTERUP/DOWNDMX Mode1CH / DMX Mode2CH / DMX Mode3CH DIR /Correlated ColourTemperatureDMX Mode3CH CCT / DMX Mode5CH / DMX Mode7CH /PatternSunlightsimulationDMX Mode12CH PAT / DMX Mode12CH SUN / DMX Mode15CH /DMX Mode36CH / DMX Mode45CH ENTERSTANDALONE MODESPress the MODE button repeatedly until “Menu” is displayed on the top line of the display. Use the UP and DOWN keys to select the menu item“Menu StaAlone” and press ENTER. Now select the desired standalone operating mode with the buttons UP and DOWN and confirm with ENTER.Menu structureMenuStaAloneENTERUP/DOWNStaAloneAuto / StaAloneSound / StaAloneCCTMacro /StaAloneTunWhite / StaAloneStatic ENTER