Menu
Calabrese ENTERTAINER Manual
             |
Instructions on how to install a Pre casted Calabrese oven kit September 2017Before you start you will need a roll of chicken wire 5 metres, tie wire and aluminium foil x 3 rolls1. On your slab roll out the Aluminium foil covering the area of your slab, Do 2 layers of foil ( Picture1). Lay your insulation board on top of the (aluminium foil ) area in where the oven will be goingkeeping centre ( Picture 2 ) . Make sure the board is at least 80mm off the back of your base toallow for insulation blanket & render (Picture 3).( the Alumium foil acts as a barrier for moisture between the slab and the insulation board )Once the insulation board is layed out,place your floor cooking tiles ontop ofthe insulation board in the followingorder listed on page 2. The tiles mayoverhang the insulation board on theleft and right of the tiles. With theoffcuts of the insulation board orexcess fibre blanket pack this underthe tiles that overhang to support tiles.PLEASE NOTE THE STANDARDINSULATION BOARD is between 40mmand 50mm thick for the Courtyard,entertainer & Grande. IF YOU RECEIVE4 pieces of 25mm thick board in yourcourtyard, Entertainer or Grande kitPLEASE DOUBLE THE SHEET UP TOMAKE 50mm..Picture 1 Picture 2Picture 3 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved