Cal Spas LTR20101000 Owner's Manual

Also see for 2010 Series: Owner's manual Owner's manual

Contents

Cal Spas LTR20101000 Owner's Manual Manual pdf 15 page image

2010 Portable SpaLTR20101000, Rev. COperating Your Spawww.calspas.com13Standard, Economy and Sleep HeatingModesYour new spa is equipped with a heating feature thatgives you complete control of the heating system.When the spa is powered up, it will automatically startin standard heating mode.St• will light briefly on the main display. In thismode, the heating system will automaticallymaintain the set spa temperature. In the economy-heating mode, the heating system will only activateduring filtration times.Ec• will display solid if temperature is not currentand will alternate with spa temperature if measuredtemperature is current.Economy mode will heat the water to the set•temperature while Sleep mode, indicated by aSL on the main display, will also only activatethe heater during the filtering cycles but willonly heat the water to within 20°F (10°C) of theset temperature. Like Economy mode, SL willdisplay solid when temperature is not current andwill alternate with actual temperature when it iscurrent.NOTE: Displayed temperature will only be current afterthe pump has been running for at least two minutes.Switching ModesPress• Temp button followed by the Lightbutton.Press the same sequence to switch to the next•mode.JetsPress the Jets button:Once to activate low speed pump.•Twice to activate high speed.•Three times to turn pump off.•LightPress the Light button to turn on the light. Press itonce again to turn the light off. All optional lightingsuch as the control panel light and cabinet perimeterlighting is controlled by the Light button and will turnon and off with the spa light.OptionPress the Option button to turn on the pump 2. Pressit once again to turn off the pump 2 (6200 controlonly).6300 Control - Pump 2 and Pump 3SequencePress• Option button once to activate high speedpump 2.Press• Option button twice to activate high speedpump 3 and high speed pump 2.Press three times to activate pump 3 high speed•only.Press four times to turn pumps off.•“Green Pack” OperationSpas with the “Green Pack” option require approximately20% less power to operate. Once the spa is properlyinstalled, it does not require any special operation.This is for your information only.When JETS 1 is pressed, the heater will operate at220V. When JETS 2 or OPTION is pressed (dependingon which control panel you have), the heater willautomatically switch to operate at 110V.With the “Green Pack”, your spa will never use morethan 30 amps while in operation.Automatic Time outsThese features will automatically turn themselves offduring periods of continuous use:Low speed pump After 4 hours•High speed pumps After 15 minutes•Optional circulation pump After 15 minutes•Optional turbo After 15 minutes•Spa light After 4 hours•Setting Filtration CyclesYour spa is programmed to filter twice a day. The firstcycle will begin 6 minutes after the spa is turned onand the second cycle 12 hours later. The factory hasprogrammed the cycle to last for 2 hours but this canbe switched to 4, 6, or 8 hours depending on yourrequirements. To set filtration time, turn off the powerto the spa at the time of day you would like one ofthe filtration cycles to begin then turn back on after30 seconds. When power has been restored, pressthe Temp button then the Jets button. Press Tempbutton again to change the filtering cycle duration.When desired duration is selected press the Jetsbutton to exit.At the beginning of each filtering cycle the Turbo systemwill run for approximately 30 seconds. The low speedpump will run for the duration of the filtering cycleand if an Ozone system is installed it will be activated.During filtering, FC will appear on the main display.