Cal Spas Avalon A526 Owner's Manual

Contents

Cal Spas Avalon A526 Owner's Manual Manual pdf 23 page image

LTR20091024, Rev. A 21Air Venturi: 1/2” line that is plumbed 18” above the spa’s water level.Topside Control Panel and Temp Sensor: 1” line that connects to the bot-tom of the control box located on the equipment pack.Electrical and Electronic ConnectionRemote Equipment Topside Control PanelThe next few steps to complete the installation should be performed alongwith installation of the temperature sensor and 12V spa light wiring (if ap-plicable). All of these components are generally installed using the sameconduit.Locate the topside control panel1.extension loom in the controlbox mounted with the equip-ment pack. This extension loomand attached black terminalconnector (see figure at right)will be used to connect the top-side control panel to the controlbox.Connect one end of the black2.terminal connector to the top-side control panel cable.Connect the other end of the terminal connector to the extension3.loom.NOTE: This connection must be kept dry. We recommend that a water-proof junction box be used in installations where moisture could penetratethis terminal connector.Lay out the extension loom to verify that you have enough length to4.reach the control box. Remember that conduit runs are not generallyrun in a straight line. Every bend, and up and down run consumesline length. Take this into consideration when verifying electrical andplumbing runs.Connect the extension loom to the control panel location on the circuit5.board located inside the control box. You will also need to connectboth the temperature and high limit sensors to the circuit board priorto testing. (See the temperature and high limit installation instructionon the next page for proper identification and see the wiring diagramon the inside cover of the control box for proper placement.)Turn on the power supply to the spa equipment and briefly test all6.functions on the topside control panel to verify that both connectionsand extension loom are in working order before proceeding with theinstallation.