Menu
Cal Amp Fusion Installation Manual
    | |
Installation InstructionsUL acceptance requires the following installation instructions. These installation instructions areavailable and may be downloaded from the www.calamp.com website listed on the CalAmp ProductInformation Card provided with each unit and include the following:1. This equipment is suitable for use in Class I, Division 2, Groups A, B, C, and D or non-hazardouslocations only.WARNING – EXPLOSION HAZARD – Do not disconnect equipment unless power has beenremoved or the area is known to be non-hazardous.WARNING — EXPLOSION HAZARD – Substitution of components may impair suitability forClass I, Division 2.2. The unit is to be powered with a Listed Class 2 or LPS power supply rated at 9 to 28 VDC orequivalent.3. Device must be installed in an end-use enclosure.4. All wiring routed outside the housing, except for the antenna, must be installed in groundedconduit, following acceptable wiring methods based on installation location and electrical code.5. The USB and SIM connectors are for temporary connection only during maintenance and setup ofthe device. Do not use, connect, or disconnect unless the area is known to be non-hazardous.Connection or disconnection in an explosive atmosphere could result in an explosion.6. Do not operate reset switch unless area is known to be non-hazardous.NON-INCENDIVE FIELD WIRINGInstallation must be in accordance with the National Electric Code (NFPA 70, Article 504) and ANSI/ISA-RF 12.6. (When the Fusion is located in a non-hazardous location, the maximum voltage is ±30 V andmaximum current is 1 A.)APPROVED ACCESSORIESThe following table shows accessories that, when approved by the manufacturer, represent antennasand cables used with modules in UL testing. |
Related manuals for Cal Amp Fusion
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved