Menu
Cafe CVW9301 Owner's Manual & Installation Instructions
                        | |
49-200006117INSTALLATION INSTRUCTIONSInstallation Instructions5 INSTALL CEILING BRACKETThe ceiling bracket must be installed when the ductcover is used to span 24” or more height abovethe hood. The bracket will hold the decorative ductcover in place at the top.NOTE: The ceiling bracket is not required whenusing only the 12” section of the duct cover.• Install the 2 small screws into the sides of theduct bracket. Remove the screws. Pre-tapping theholes will insure ease of final installation.• Match center notch on the bracket to thecenterline on the wall and flush against the ceiling.• Mark the 2 screw hole locations.• Drill 2/8” pilot holes in marked bracket location.• If pilot holes do not enter studs, enlarge the holesto 3/8” and install wall fastener anchors.• Secure the bracket to the rear wall with woodscrews and washers. Use wall anchors if needed.NOTE: Bracket has 2 sets of holes. Use larger holesfor wall fasteners or wood screws with washers. Usesmaller holes for wood screws with washers.6 CONNECT DUCTWORK• Push duct over the end of the transition until itreaches the stop tabs.• Install ductwork, making connections in directionof airflow as illustrated.• Secure joints in ductwork with sheet metal screws.• Wrap all duct joints with duct tape for an airtightseal.• Use duct tape to seal the flange connectionCAUTION Do not use sheet metal screws atthe transition to ductwork connection. Doing se willprevent proper damper operations. Seal connectionwith tape only.Install CeilingBracket WhenDuct Cover isUsed to Span24” or moreSee Step9 to InstallDuct Cover.Duct StopsDuct Tape OverSeam and ScrewDuct TapeOnly for ProperOperation ofDamperDuct Tape Over FlangeAir FlowHouseDuctworkTransitionDuctworkScrew |
Related manuals for Cafe CVW9301
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved