Cadillac Escalade Manual

Also see for Escalade: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Cadillac Escalade Manual Manual pdf 48 page image

Navigation Audio SystemNotice: Before adding any sound equipment toyour vehicle, like a tape player, CB radio, mobiletelephone, or two-way radio, make sure that it canbe added by checking with your dealer. Also,check federal rules covering mobile radio andtelephone units. If sound equipment can be added,it is very important to do it properly. Addedsound equipment may interfere with the operationof your vehicle’s engine, radio, or other systems,and even damage them. Your vehicle’s systems mayinterfere with the operation of sound equipmentthat has been added improperly.Your vehicle has a feature called Retained AccessoryPower (RAP). With RAP, the audio system can beplayed even after the ignition is turned off. See“Retained Accessory Power (RAP)” in Section 2 of yourvehicle’s owner manual for more information.The audio system is operated using navigation systemmenus. The audio menus are explained in this section.Playing the RadioO (Power/Volume): Press this knob to turn the audioand navigation systems on and off. Turn the knob toincrease or decrease the volume.Finding a StationBAND: Press this hard key to access the BAND screenand to switch between AM, FM1, FM2, XM1, andXM2, if equipped.Tuning Knob: Use the tuning knob on the lower leftcorner of the navigation system to choose a radio station.w SEEK x: Press the SEEK up or the down arrow togo to the next or previous station and stay there.To scan stations, press and hold the SEEK up or downarrow for two seconds until you hear a beep. Theradio will go to a station, play for a few seconds, thengo on to the next station. Press either SEEK arrow againto stop scanning.To scan preset stations, press and hold the SEEK up ordown arrow for more than four seconds. You will heartwo beeps and PSCAN will be displayed, along with thehighlighted preset. The radio will go to one of thepreset stations, play for a few seconds, then go on tothe next preset station. Press either SEEK arrowagain to stop scanning presets.The radio will only seek and scan stations with a strongsignal that are in the selected band3-2