How to Check Power Steering FluidLocate the cap with thissymbol. See EngineCompartment Overview onpage 5-12 for moreinformation on location.To check the power steering fluid, do the following:1. Turn the key off and let the engine compartmentcool down.2. Wipe the cap and the top of the reservoir clean.3. Unscrew the cap and wipe the dipstick witha clean rag.4. Replace the cap and completely tighten it.5. Remove the cap again and look at the fluidlevel on the dipstick.The level should be at the FULL COLD mark.If necessary, add only enough fluid to bring thelevel up to the mark.What to UseTo determine what kind of fluid to use, seeRecommended Fluids and Lubricants on page 6-13.Always use the proper fluid. Failure to use the properfluid can cause leaks and damage hoses and seals.Windshield Washer FluidWhat to UseWhen you need windshield washer fluid, be sure to readthe manufacturer’s instructions before use. If you willbe operating your vehicle in an area where thetemperature may fall below freezing, use a fluid that hassufficient protection against freezing.Adding Washer FluidYour vehicle has a low washer fluid message thatcomes on when the washer fluid is low. The message isdisplayed for 15 seconds at the start of each ignitioncycle. When the LOW WASHER FLUID messageis displayed, you will need to add washer fluid to thewindshield washer fluid reservoir.5-35
