Black plate (60,1)Cadillac CTS Owner Manual (GMNA-Localizing-MidEast-8087697) - 2015 -crc - 6/18/1410-60 Vehicle CareCaution (Continued)products can be obtained fromyour dealer. Follow allmanufacturer directions regardingcorrect product usage, necessarysafety precautions, andappropriate disposal of anyvehicle care product.{ CautionAvoid using high-pressurewashes closer than 30 cm (12 in)to the surface of the vehicle. Useof power washers exceeding8,274 kPa (1,200 psi) can resultin damage or removal of paintand decals.The e symbol is on anyunderhood compartment electricalcenter that should not be powerwashed. This could cause damagethat would not be covered by thevehicle warranty.If using an automatic car wash,follow the car wash instructions. Thewindshield wiper and rear windowwiper, if equipped, must be off.Remove any accessories that maybe damaged or interfere with the carwash equipment.Rinse the vehicle well, beforewashing and after, to remove allcleaning agents completely. If theyare allowed to dry on the surface,they could stain.Dry the finish with a soft, cleanchamois or an all-cotton towel toavoid surface scratches and waterspotting.Finish CareApplication of aftermarket clearcoatsealant/wax materials is notrecommended. If painted surfacesare damaged, see your dealer tohave the damage assessed andrepaired. Foreign materials such ascalcium chloride and other salts, icemelting agents, road oil and tar, treesap, bird droppings, chemicals fromindustrial chimneys, etc., candamage the vehicle's finish if theyremain on painted surfaces. Washthe vehicle as soon as possible.If necessary, use non-abrasivecleaners that are marked safe forpainted surfaces to remove foreignmatter.Occasional hand waxing or mildpolishing should be done to removeresidue from the paint finish. Seeyour dealer for approved cleaningproducts.Do not apply waxes or polishes touncoated plastic, vinyl, rubber,decals, simulated wood, or flat paintas damage can occur.{ CautionMachine compounding oraggressive polishing on abasecoat/clearcoat paint finish(Continued)
