Menu
CableWorld CW-4000 Series User Manual
Also see for CW-4000 Series: User guideUser guideUser guideUser guideUser guide
  |
CW-4000USER'S GUIDEDear User!In spite of the rapid spreading of digital televisiontechnology input signals for earlier analogue TVmodulators and monitors will still be needed in the next fewyears. The models of CableWorld’s Multistandard MPEGdecoder series comprise one or two independentMPEG/H.264 decoders. All the versions are equipped withASI and IP inputs but the CW-4673 and the CW-4674models allow receiving scrambled channels, too.The Multistandard MPEG decoders have user friendlyweb interfaces, which serves the demands of both less andhighly skilled users.The separated management port allows programmingand control of the device in a network separate from thetrunk lines.1. MECHANICAL CONSTRUCTIONThe DVB-S2 Satellite Receiver and DVB-T OFDMReceiver is built in standard 19" x 1 HU instrumentframe. It is delivered along with the followingaccessories:1. Power cord 1 ea.2. Spare fuse T 1.25 A(placed in the fuse holder mounting) 1 ea.3. Crossover cable with RJ45 connectors 1 ea.4. Cover cap for the optical receptacle 1 ea.The power consumption of the device is very low, needsno special cooling or ventilation.2. ELECTRICAL CONSTRUCTIONThe device is equipped with own switching modepower supply. The supply voltage of the interfacecircuitry is +3.3 V, but the signal processing circuitryworks with supply voltages of +1.2, 1.8 or +2.5 V. Thereal power consumption of these devices is low, theyare suitable for continuous operation, however theheat resulting from the few 10 watts of powerconsumption must be dissipated. In most cases thenatural cooling is enough.The device circuitry comprises high complexitycircuits, which should be configured to the given taskby the user.3. PUTTING THE DEVICES IN OPERATIONAfter unpacking remove the protection foil from thestainless steel cover of the device. Connect the deviceto the specified mains voltage and switch on the powerswitch. After a few seconds the device is ready tooperation.Programming the device and saving the settings isrequired only when putting the device in operation firstor when modifying the settings.The device has a web user interface and can beset and programmed via the Management Port.The default IP address of the Management Port is192.168.10.10. After building up the communicationwith the device, it can be programmed to the desiredvalue via this input. Pressing the Reset switch sets theManagement Port IP address to 10.123.13.101.Using the web interface requires a web browser.Our software is tested only in Firefox browser. In otherbrowsers the surface may vary in appearance, properoperation is not guaranteed. For some special tasksthe browser's performance is not enough, so weintegrated Java Applet. Running the Java programpart requires a newer version of Java installed inadvance.To display the user interface connect your PC tothe Management Port. Use a crossover cable for directconnection and straight cable via switch. On startingthe web browser enter the Management Port IPaddress in the window of the browser. The userinterface will appear on the monitor screen in a fewseconds.The short and concise help available via the userinterface supports setting up the device. From ourwebsite ( www.cableworld.hu) we want to help ourusers' work with more information, professionalarticles, software, etc.13/14MULTISTANDARD MPEG DECODERCW-4671, CW-4672, CW-4673, CW-4674 |
Related manuals for CableWorld CW-4000 Series
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved