Bosch WAW32640TH Instruction Manual And Installation Instructions

Also see for 8 Series: Instruction manual Recipes Instruction manual Installation instructions Assembly instructions

en Programme default settings360 Programme defaultsettingsProgrammedefaul t setti ngsThe default programme settings aredisplayed in the display panel afterselecting the programme.You can change the default settings.An overview of all programme settings,which can be selected depending onthe programme, can be found from~ Page 29.Temperature°C sDepending on what stage theprogramme is in, you can change theset temperature before and during theprogramme.The maximum temperature that can beset depends on the programme that hasbeen selected.Spin speed(Spin 0)Depending on what stage theprogramme is in, you can change thespin speed (in rpm; revolutions perminute) before and during theprogramme.Setting 0: The rinsing water is drainedbut there is no final spin. The laundrystays wet inside the drum, e.g. for itemsthat should not be spun.Setting $: Rinse Stop = no final spin.The laundry stays in the water after thefinal rinse.You can select “Rinse Stop” to preventcreasing if the laundry will not be takenout of the washing machine immediatelyafter the programme has ended.To continue/end the programme~ Page 41The maximum speed that can be setdepends on the model and programmethat has been selected.Ready in ñBefore starting the programme, youcan preselect the programme end("Ready in" time) in hourly increments (h= hour) up to a maximum of 24 hours.To do this:1. Select a programme.The programme duration is displayedfor the selected programme, e.g.2:30 (hours:minutes).2. Press the Ready in ñ buttonrepeatedly until the required numberof hours is displayed.Note: The setting values areincreased using the Ready in ñ +button, and decreased using theReady in ñ - button.3. Press the A button.The programme starts.The selected number of hours(e.g. 8 h) is shown in the displaypanel and counts down until thewash programme starts. The durationof the programme is then displayed.Note: The length of the programme isautomatically adjusted when theprogramme is running. Changes to thedefault programme settings orprogramme settings may also changethe programme duration.After starting the programme (if aReady in ñ time has been selected andthe wash programme has not yetstarted), you can change thepreselected number of hours as follows:1. Press the A button.2. Use the Ready in ñ - or + button tochange the number of hours.3. Press the A button.After starting the programme, you canadd or remove laundry if necessary.~ Page 41