Bosch VDN-5085 Installation Manual

Also see for DIVAR AN 5000: Installation manual User guide Manual Operation manual Installation manual

14 en | Installation FLEXIDOME 5000 ANAM18-Q0648 | v1.0 | 2013.03 Installation Manual Bosch Security SystemsTo disassemble the unit proceed as follows:1. Use the special screwdriver bit to loosen the three tamper-resistant screws in the trim ring (the screws remain inplace).2. Remove the trim ring and dome by pulling them from thebase.3. Remove the inner liner (with sealing ring) by pulling it offof the base.4. Remove the pink protective foam.3.3 Mounting the unitThere are several ways to mount the unit. The method ofmounting depends on the type of surface and whether othermounting hardware, such as an electrical box, a surface box orother accessories are used.Note:Figure 3.2 Surface-mountSurface mounting boxCamera module and mounting baseInner liner (with sealing ring)Trim ringDome