Bosch SMI88TS05E Instruction Manual

Also see for 8 Series: Instruction manual Recipes Instruction manual Installation instructions Assembly instructions

Operating the appliance en291 Operating theapplianceOperatingtheappliance Programme dataThe programme data (consumptionvalues) can be found in the summaryof instructions. They refer to normalconditions and the water hardness setvalue °E 16 - 20 medium. Differentinfluencing factors such as watertemperature or line pressure may resultin deviations.Changing the settingsThe dishwasher has been preset withcertain settings for your convenience.You can change these factory settings.Change the setting as follows:1. Open the door.2. Switch on ON/OFF switch (.3. Press Info button {8 for 3seconds until the following text isindicated on the display window atthe top @:Scroll with < >Set with - +Leave with Setup 3 sec.4. Keep pressing button >)* until therequired setting is indicated on thedisplay window at the top @.5. Make the setting with setting buttons+ -X.6. Press and hold the Info button {8 for 3 seconds.The chosen setting has now beenstored.Tip: If you change several settings, firstmake all changes in succession. Nowpress the Info button { 8 for3 seconds. This saves all set values inthe appliance.AquaSensor *AquaSensor * depending on the features of yourdishwasherThe Aqua sensor is an opticalmeasuring device (light barrier) whichmeasures the turbidity of the rinsingwater.The AquaSensor is used accordingto the programme. If the AquaSensor isactive, “clean” rinsing water can betransferred to the next rinse bath andwater consumption can be reduced by3–6 litres. If the turbidity is greater,the water is drained and is replacedwith fresh water. In the automaticprogrammes the temperatureand running time can also be adjustedto the degree of soiling.