Bosch SHV89PW53N Operating Instructions Manual

Also see for SHV89PW53N: Operating instructions Operating instructions

Rinse Aid en-us172. Add liquid rinse aid to thedispenser 9* until it is full. Donot overfill.3. Close the lid. Lid must be fullyclosed until it clicks in order toseal.4. Wipe up any excess rinse aid thatmay have puddled when thedispenser reservoir is full.The indicator light will go out a fewmoments after the dishwasher dooris shut.NOTICEDo not fill the rinse aid dispenser 9*with detergent. Doing so will damagethe dishwasher.Setting the amount of rinseaid usedThe amount of rinse aid dispensedcan be set from 0 to 6. Set theamount of rinse aid to be dispensedto 5 to obtain a very good dryingresult.You should only change the setting ifstreaks remain on the dishes (lowerthe amount), or if dishes are notgetting dry enough (increase theamount).Set the amount of rinse aid asfollows:1. Open the door.2. Switch on On/Off button (.3. Press Info button 8 for3 seconds until the following textis indicated on the display windowat the top @:Scroll with < >Set with - +Leave with Setup 3 sec.4. Keep pressing button > )* untilthe rinse aid dispenser isindicated on the display windowat the top @.5. Make the selection with settingbuttons + - X.6. Press and hold the Info button8 for 3 seconds.The chosen setting has now beenstored.Turning off rinse aidindicatorProceed as described in the section“Setting the amount of rinse aidused” and set value to 0. The rinseaid indicator is now turned off.NOTICEUsing no rinse aid or setting thedispenser to 0 may result in longercycle times consuming more energyand water. The higher temperaturesand longer cycle times can damagefine china or glassware.PD[