Bosch SHE53CE5N Quick Start And Safety Manual

Also see for FAP-OC 500Series: Use and care manual Use and care manual Use and care manual Operating instructions Instructions for use

6 Frequently Asked QuestionsQ: Why is food remaining on dishes after I run the cycle?• It is possible the dishes do not have adequate clearance between them. Also, be sure nothing is blocking the spray arms andthat the filter is clean. Select the Heavy cleaning cycle.Q: Why does the cycle run a long time?• Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected.• Incoming water may not be hot enough and dishwasher has to heat it.Setting Factory setting DescriptionRinse AidOff/Low/Medium/HighMedium Setting to adjust the amount of rinse aidused in each cycle.Intensive dryingOff/OnOff Setting to increase drying ability for glass-es or plastic. Increases cycle length andtemperature.End of cycle toneOff/Low/Medium/HighMedium The volume of the tone signalling the endof cycle.5 Settings5.1 Available SettingsBelow are some commonly used settings. To see all the settings refer to the full online manual or go to Dishwasher » Settings inthe Home Connect® app.5.2 Adjusting the settingsFirst Steps to adjust any setting:Open the door and press the ON/OFF button.Hold down Button A for 3 seconds, until the Rinse Aidindicator light flashes.Release button, then follow steps below to adjust specificsetting.To adjust the rinse aid:1. Press the Start button repeatedly until the right amountof rinse aid has been set. 0 (off), 1(low), 2(medium),or 3(high) LEDs above cycle buttons will light upaccordingly.2. Press button A for 3 seconds to save the setting.To turn on intensive drying:1. Press button A until the Clean and Sanitize lights flash.2. Press the Start button until 1 LED light above the heavycycle button is on (intensive dry is on).3. Press button A for 3 seconds to save the setting.To adjust the signal volume:1. Press button A until the Clean and Rinse Aid lights flash.2. Press the Start button repeatedly until the preferredvolume level has been selected. 0 (off), 1(low), 2(medi-um), or 3(high) LEDs above cycle buttons will light upaccordingly.3. Press button A for 3 seconds to save the setting.To reset to factory settings:1. Press button A until the Clean, Sanitize and Rinse Aidlights flash.2. Press the Start button. The 3 LEDs above cycle buttonswill blink alternatively for 1 minute. The factory settingshave been restored.Tip: The simplest way to change the settings is with theHome Connect® app.