Bosch Remote Control User Manual

Also see for GWH C 800 ES: Service bulletin Technical service bulletin Technical service bulletin Service bulletin Technical service bulletin

Contents

16Troubleshooting6 720 606 9906.5 Error messagesThis device has an error messagesystem. Any errors that the heatergenerates will be indicated by an errorcode that will appear on the display(Fig. 10, pos. 1) and by a symbolindicating a "safety block" (Fig. 10,pos. 7). The remote control will beoperative only after pressing the resetbutton on the heater and clearing theerror.To identify the type of error or if theerror will not clear, consult the heaterinstallation manual.7 Troubleshooting7.1 Replacing batteriesWhen batteries are weak, the lowbattery symbol (Fig. 10, pos. 5) willappear on the display.B Remove the two screws on the backof the remote control.B Open the battery housing andremove the batteries, then replacewith new AA 1.5V batteries,ensuring they are inserted correctly.B Close the battery housing using thetwo screws.7.2 CleaningUse a damp cloth to clean parts of theremote control. Do not use abrasive orsolvent-based detergents.7.3 Troubleshooting1. No display on remote controlB Check for weak or dead batteries(see section 7.1).Remote control in sleep mode.i "Priority" cannot beacquired while the hotwater tap is open. i Verify that the rubberseal is correctly fittedbetween both plastichousing parts.Warning: deadbatteries must bereplaced.Consequently, themanufacturer is notliable for any faults ordamage caused bydead batteries.Dispose of the deadbatteries properly.